![]() Unfortunately, my WD and Seagate HDD are not show up in the Boot Priority EZ Mode and Boot Option in Advanced Mode > Boot. U boot list devices windows#Also, in the BIOS it shows Windows Boot Manager: Samsung SSD and Samsung SSD in the boot priority as well as my optical drive. Now, I can boot into the OS with CSM disabled no problem. I figure out that my BIOS Mode was set to Legacy instead of UEFI, so I converted my OS Samsung drive to GPT without data loss. It should be similar to the following, with an EFI partition present: You can detect if you are using UEFI boot type by running the Windows disk management console and look at the partition scheme for your Samsung SSD. I don't think this is a problem for you, and you should still be able to use the Seagate and WD HD for data storage. If you have UEFI booting, the Seagate and WD HD would not show up in the Boot Priority list because there isn't a Windows Boot Manager installed on them. U boot list devices install#Windows DVD install disk) will show up in the Boot Priority List. Samsung SSD containing the partition EFI/BOOT/bootfwmg.efi) or can have the boot manager (e.g. It could be that your boot type is UEFI, and therefore only devices that have the UEFI Windows Boot manager (i.e. The Seagate and WD HD and not considered to be boot devices. It appears that the BIOS considers only your Samsung SSD and optical disc drive to be bootable devices. Launch CSM was enabled as well." Enabling Legacy OPROM means that older devices can be used for booting, and this requires CSM enabled: "Compatibility Support Module" allows for older boot devices. I see that you have an older motherboard with Z97 chipset, and you said "Boot Device Control was set to UEFI and Legacy OPROM. Only my OS SSD and my optical drive display in the Boot Priority. I did tried my laptop hard drive to see if my 2 hard disk drives are dead, and the result is the same as before. But if I try all my 4 drives at the same time, only 2 will display which are my OS SSD and my optical DVD/CD drive. The thing is if I try one drive at a time, it will displays it in the Boot Priority. Next Boot after AC Power Loss > Fast Boot I don't think my HDD is dead because Windows are able to detect my two hard disk drives. If I try to power on individual drive, the motherboard will display it in the Boot Priority, but if I try to power on all my 4 drives, only 2 drives will display in Boot Priority. U boot list devices how to#I don't know what's going on and how to fix it. My two hard disk drives have drive letter. Boot Device Control was set to UEFI and Legacy OPROM. My 2 other hard disk drives were not showed up in the boot priority, but it does showed up in boot menu, SATA Information on the EZ Mode tab, Boot Override tab in the Advanced Mode, and Hard Drive BBS Priorities. Out of the 4 drives, only 2 showed in Boot Priority which are my OS SSD and my optical drive. I have 4 drives that are connected to the motherboard top 4 SATA ports. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |